A new way to listen for a new iPhone era
Keeping your favourite 3.5mm headphones around: The Fiio i1 is an Apple MFi certified, digital-to-analog converter (DAC) and amplifier designed for the Apple Lightning connector. The digital audio signal enters through the Lightning connector end that can be connected to the Apple iPhone/iPod/iPad (and other Apple products), while the analog audio signals are pushed out through the 3.5mm output.
The i1 also automatically detects if you are using a standard headphone or one with in-line controls. Just because Apple has ditched the headphone jack doesn't mean you have to ditch your favourite headphones.
High-Performance DAC chip for better quality than iPhone's stock DAC: Within the i1 is a high quality chip with both a DAC and a headphone amplifier. Not only does this chip support lossless audio formats, as well as achieve a high signal-to-noise ratio and low distortion, it also supports high definition voice calls to give you crystal-clear conversations anytime, anywhere. (The i1 currently only supports up to lossless 48kHz audio due to the Lightning Audio Module (LAM) - this may change to up to 192kHz pending changed to the LAM.)
High quality microphone that clearly captures your voice: Built into the i1 is a high-sensitivity microphone that ensures your voice is clearly heard during calls and recordings - no more miserable conversations due to poor voice quality.
Diemensions: 45.5mm in length, 9.5mm in diameter
Cable Length: 80cm
Output Interface: 3.5mm stereo jack
Output Power: 30 mW (16 ohm loaded)
Frequency Response: 20Hz - 20kHz
Supported Devices: (Compatiable with iOS 8.0 and above) iPhone 7/iPhone 7 Plus/iPhone 6s/iPhone 6s Plus/iPhone 6/iPhone 6 Plus/iPhone 5s/iPhone 5c/iPhone 5
iPad Pro(9.7-inch)/ iPad Pro(12.9-inch)/iPad Air 2/iPad Air/ iPad(4th generation)/iPad mini 4/iPad mini 3/iPad mini 2/ iPad mini
iPod touch (6th generation)/ iPod touch(5th generation)
CODEC Chip: NAU88L25